What is film faced plywood used for?
Film faced plywood is used for concrete formwork on slab decks, walls, columns, foundations and beams, and for exposed or fair-faced concrete where the finished face will be seen. Outside the pour it also turns up in temporary works such as site hoarding, where a smooth, water-resistant face is needed for a limited period. Covered work and short programmes sit well on a Class 2 grade such as Form Basic, while a long reuse run or rain between pours points to a Class 3 grade such as Pro Form Lite or Pro Form, especially on fair-face work.
Is the brown film the same thing as phenolic Class 3 glue?
No. Face film and core glue are separate lines on the data sheet, and Vinawood formwork faces are phenolic kraft paper on every grade. The core is either MUF, rated EN 636-2 Class 2 on Eco Form Plus, Form Basic and Form Extra, or phenolic, rated EN 636-3 Class 3 on Pro Form Lite, Pro Form, HDO Standard, HDO Premium and the MatteFace Panel 1S, Panel 2S, 1SF and HD 1SF grades. HDO Basic and MatteFace Eco 1SF, the latter bonded with M-Bond glue, are rated Class 2, so write the class number on the PO rather than relying on the film colour.
What overlay gsm and EN 314 bond class belong on a formwork RFQ?
Name the film weight separately from the veneer bond, because they are two different lines on the data sheet. Pro Form carries a 125 g/m² phenolic film, while Form Basic, Form Extra, Pro Form Lite and Eco Form Plus carry 165 g/m². Bond quality is tested under EN 314-2, and exterior formwork programmes usually write EN 636-3 or Class 3 when the core is phenolic. A heavier overlay does not upgrade an MUF Class 2 core, so put both gsm and bond class on the RFQ before discussing price.
How many reuses can film faced plywood take on a pour programme?
Reuse is always quoted as up to N under good site care, never as a guaranteed minimum. Typical Vinawood ceilings are up to 8 for Eco Form Plus, up to 10 for Form Basic and HDO Basic, up to 15 for Form Extra and Pro Form Lite, and up to 20 for Pro Form, HDO Standard and HDO Premium. MatteFace runs up to 15 on the 1S and 1SF panels, up to 17 on HD 1SF and up to 25 on the 2S panel. Sealed edges and flat stacking, plus a proper release agent, decide whether a site actually reaches those numbers.
What sizes and thicknesses does film faced plywood come in for concrete formwork?
Standard formwork plywood sizes on the Vinawood film-faced grades are 2440×1220 mm, the metric match for a 4×8 ft sheet, and 2500×1250 mm, which European crews and system-formwork users tend to prefer. Thicknesses run from 11.5 mm up to 21 mm, with 12, 15, 18 and 21 mm offered across Eco Form Plus, Form Basic and Form Extra in both sizes. Thickness is chosen against pour pressure and the joist spacing behind the sheet, which is why 18 mm is where most wall and slab crews start. Put size and thickness on the RFQ next to film weight and bond class so every quote prices the same panel.
Where do importers buy mill film faced plywood for concrete formwork?
Factory-direct mill supply is the usual B2B route, and it works best when the RFQ names overlay gsm, bond class (EN 636-2 or EN 636-3), size and thickness, plus reuse as up to N. Vinawood has pressed formwork plywood in Vietnam since 1992 and ships from Hai Phong. Start with the film-faced collection or send your spec through the quote form, since big-box SKUs and hobby phenolic birch boards serve a different buyer.